Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

follow up on Noisy Throwout Bearing Lubracate? YES it worked!!! 200 1988

posted by  vrrroom on  Sun May 8 09:36 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 19 17:01 CST 2014
[RELATED]

I got a lot of advice both yes and no on oiling the noisy throwout bearing. Bearing had only 30k on it and I did not want to go back in and swap it out. Sooo I tapped about 12 inches of stiff poly 1/4" clear hose on a pump squart oil can. Oil was half 30w and marvel oil mix. Pulled rubber clutch fork cover back. With small flashlight and makeshift oiler shout a few drops of oil on bearing. Fired up 244 and still had bearing noise:-( Oh well, I tried. Then wala, a day later noise stopped:-) Oil must of taken time to soak in. It has been noiseless for several days now. Keeping my fingers crossed.

Thanks to all who said yes it could be done.

Gary in Maine






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New follow up on Noisy Throwout Bearing Lubracate? YES it worked!!! [200][1988]
posted by  vrrroom  on Sun May 8 09:36 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.