Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2008 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

rotor and pad replacement 900 1993

posted by  ajs on  Mon Jun 20 12:51 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jul 1 11:32 CST 2014
[RELATED]

I have just attempted to replace the front rotor and pads of my 1993 940T with Girling single piston caliper (with ABS). As part of the procedure I pumped the piston out an inch or so, so that I could clean the exposed piston. I pushed the piston back and now cannot seem to get the new aftermarket pads (PBR 1198)into place without compromising the seals. Has anyone else had similar problems? It looks to me like the pads are too thick (the new rotor is 26mm thick), they measured 0.7".





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New rotor and pad replacement [900][1993]
posted by  ajs  on Mon Jun 20 12:51 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.