Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

info requested on tools needed for pinion shaft oil seal job 200 1989

posted by  someone claiming to be 2oldvolvos on  Thu Aug 11 03:14 CST 2005 [RELATED]


Dear Brickboard,

My 1989 240 DL sedan has started to leak out of the rear end just behind where the drive shaft is connected to it.

I suspect my pinion shaft oil seal should be replaced.

My Haynes manual says that I will need a Volvo special tool (or substitite) to pull the shaft flange and a Volvo special tool (or substitute) to press the flange back on.

It seems to me that it would be wise to use special tools rather than to start banging around on the rear end with a hammer and pry bar.

Do any of you know where how I can purchase, borrow, or make the special tools I will need? I assume that going to Volvo is not a viable option.

It looks to me like if I try to make a tool, I may need to have a bolt that will fit into the flange shaft. I have no idea what size I need or if it is SAE or metric.

Please advise. Thank you.

2OldVolvos






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New info requested on tools needed for pinion shaft oil seal job [200][1989]
posted by  someone claiming to be 2oldvolvos  on Thu Aug 11 03:14 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.