Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2007 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

JB Weld??? 120-130

posted by  122_Canadian on  Fri Sep 16 04:59 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 20 07:51 CST 2009
[RELATED]

Hi Mario.

It was pretty simple. The top cover was only warn in one direction (the slot was bigger toward 1st and away from 3rd...can't explain it all that well, but if your's is warn, you'll see). Anyway I first cleaned up the area (the previous owner put a bunch of graphite goop to try to make the shift better), and roughened the area with my trusty Dremel. Then I cleaned it all with a Q-tip and acetone. I put masking tape around the inside and outside to make a dam for the JB. Then mixed it up and let it set for 20 minutes to get some body (as per instructions on the package). The I filled the dam.

Next, I re cut the slot with my Dremel and put it back to gether. Worked just fine. It still isn't perfect, but it is a definite improvement.

Cheers,
Craig






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Oil out the breather cap??? [120-130]
posted by  122_Canadian  on Thu Sep 15 06:36 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.