Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

-Fixed !!!! HALL UNIT 700 1986

posted by  volbro245 on  Sat Oct 22 09:28 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Nov 6 18:05 CST 2013
[RELATED]


When to the local auto recycler, got another distributor and ignition amp- $100.
Plugged the distributor to the three wire connector, key on, coil wire about 25mm from the block. Rotated the shaft and got both spark and injector and fuel pump action. Reinstalled everything. Started up just fine and the engine runs very very smooth thanks the new engine harness.

Near as I can tell, when I routed the new engine harness around the back of the block, I bumped the previously repaired connector at the bottom of the distributor. This caused the car not to run. Even though I repaired that with a new volvo connector,the Hall unit must have been damaged.

Good puzzle, learned more than I need to about Volvo ignitions. So the wire harness took about 3 hours to install, the trouble shooting on the ignition took me several nights over the past week.

Mike

--
In Tacoma '86 245 200K+ and '86 740T- 215K+ both with M46






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replaced engine harness- wont run [700][1986]
posted by  volbro245  on Sun Oct 16 05:28 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.