Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2017 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Good tools to have? 700

posted by  Sumerduckman on  Wed May 24 11:01 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Aug 21 11:31 CST 2007
[RELATED]

I know the ones that they will have to pry from my cold dead hands.

Long handle, 4 ton garage/service jack.

1/4 inch drive, small Matco air wratchet with a double swivel connector.
Can fit the thing just about anywhere to run nuts/bolts on and off, hose clamps etc.

Old 2 speed Makita 1/2 inch electric impact wrench. Settings for 100ftlbs or 150 ftlbs max torque, 3000 impacts/minute. Will use for over 90 percent of jobs. The impacts, and not the grunt will loosen most. Can set it to the low speed so you can run stuff back in without fear of over torquing. Variable speed so very easy to 'feather', very light and no heavy hose to drag around. If it will not do the job, then the air impact comes out.
--
Gary Gilliam Sumerduck VA, '94 940 Regina , '86 240gl






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Good tools to have? [700]
posted by  Andrew in AL subscriber  on Wed May 24 09:24 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.