Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2013 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

rod width? 140-160

posted by  jparker3 on  Tue May 30 02:50 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jun 9 18:47 CST 2009
[RELATED]

I have also seen the B20 rods listed with a width of 1.115 - 1.117, butI measured the B20 8 bolt rods to be sure when I was considering doing a less expensive stroker engine by using off the shelf rods with an offset groud crank and found they were at least .050. wider than the Mitusbishi rods in question.
There is a Mitsubishi rod that is a similar width, within a few thou, from a 2.6 L engine, but the rod length is all wrong.

Of course the early B20 is even wider at 1.250.

Dyno tests on some of our strokers will be available soon.

John
V-performance.com





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New trottle body size? [140-160]
posted by  fidel  on Tue May 16 10:28 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.