Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

replace solonoid? 200 1990

posted by  rstarkie on  Thu Aug 24 11:05 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:14 CST 2014
[RELATED]

You are getting ahead of yourself. Swen's maintainer has layed out the route you can follow to chase this problem down. Go after the overdrive relay.

A jumper is simply a short section of wire used to connect two points. In this case two spades on the relay.

Pull the glovebox out. Find the relay around the left hand corner of the opening. Unplug it. Look at the ends with the terminals. See the numbers beside the terminals? Make a small jumper wire and connect the terminals 15 and 87. Use a small diameter wire and don't allow it to touch other terminals. Push it down against the base of the relay and then plug it back into the connector.

Go for a test drive and report back with the results.

Randy






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 dl transmission arrow stays on [200][1990]
posted by  roeleveld  on Thu Aug 24 08:53 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.