Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Installing a third row jumpseat 200 1991

posted by  muzmuz on  Tue Aug 29 05:28 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I am trying to install a third row seat in my '91 240 wagon. Most of it seems fairly straight forward, but there's bracket that holds the latch when the jumpseat is open. In the wagon I took the seat out of, this bracket is bolted to a nut recessed in the steel bed of the wagon. In my wagon there is no hole with this recessed nut. Is my only option to drill a whole in the bed and use a nut with a flange below the steel of the bed?

The lower part of the seatbelts for the jumpseat seem to mount to a similar hole near the bottom of the interior side of the rear wheel wells? Any idea if those holes are present in my car before I tear up the carpeting to find out for sure?

Thanks,
Muz






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Installing a third row jumpseat [200][1991]
posted by  muzmuz  on Tue Aug 29 05:28 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.