Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2023 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Removing intake manifold, replacing engine wiring harness 200 1984

posted by  someone claiming to be TwoFortyTom on  Thu Aug 31 05:13 CST 2006 [RELATED]

The Bentley's mention of coolant in the manifold comes from the few carbureted versions of the 240 which aren't covered anyway. Just leads you astray. No need to dump coolant.

The injectors are all on the same two wires - you can plug any one that reaches reasonably. No need to sort them out. But make sure you don't mix up the idle air 3-pin with the throttle switch 3-pin.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Removing intake manifold, replacing engine wiring harness [200][1984]
posted by  volvogeek  on Thu Aug 31 05:05 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.