Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Removing intake manifold, replacing engine wiring harness 200 1984

posted by  volvosfive on  Thu Aug 31 05:13 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 21 08:01 CST 2011
[RELATED]


Hi,

No need to drain the cooling system unless you want to replace the heater hoses while you're in there. It's much easier to replace them with the intake manifold removed. Also, just unbolt the manifold and pull it back by the driver's side strut tower. No need to completely remove it.

There's no special way to reconnect the fuel injector wire plugs. They're batch fire so it doesn't matter.

Good luck.
Dave






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Removing intake manifold, replacing engine wiring harness [200][1984]
posted by  volvogeek  on Thu Aug 31 05:05 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.