Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2000 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

windshield leak 120-130

posted by  lee on  Mon Sep 11 04:52 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jul 1 22:19 CST 2013
[RELATED]

Before you paste the windshield with sticky goo check the seals for your windshield wipers. I know it's a long shot but sometimes the grommets loosen up and water will get in around the wiper posts.

Whatever you do stay away from the silicone rtv sealers. Air humidity causes the rtv to cure, therefore the rtv will absorb enough water to do a good job of rusting all the steel it comes in contact with. The Butyl rubber based sealers used in modern glue down windshields is messy stuff, but I think it's still the best stuff out there.

If you have been leaking theres going to be moisture sealed in to the leak site when you seal it. You should pull the windshield and attend to the bodywork as soon as you can to minimise the advancement of rust.
--
Lee 75 240 (75k original miles) 65 220 project






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New windshield leak [120-130]
posted by  honeychrome  on Mon Sep 11 02:19 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.