Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2002 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Spark (It Runs!!) 700

" So I took the Rex square coil apart (two Torq screws) and used sandpaper on the contacts and surface(?) of coil and module."

Did you coat the mating surface between coil and module (heatsink) like I pointed out earlier in this thread (Thursday)? I believe it's important in transferring heat away from the coil.
See repeat below:


==>"The advice as I recall it is to remove the heatsink, clean off the mounting surfaces on both parts, then remount the coil using fresh "Heat Sink Grease" (Radio Shack 276-1392)."<==

--
Bruce Young
'93 940-NA (current), 240s (one V8), 140s, 122s, since '63.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New No start 1990 740 GL repeat. [700]
posted by  rabo  on Fri Oct 27 11:34 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.