Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

TAB time 200 1991

uid 39111's pic
posted by  Kenner on  Sat Nov 25 14:05 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 24 15:42 CST 2014
[RELATED]

It's TAB time. The job i have been procrastinating about. Got them in the mail Friday front and rear, and picked up my shocks and a new pair of springs while I was there.
Question.
The FEBI tabs are not perfectly round. Is this normal? I am not talikng tapered is i know they are, but diameter up and down is greater than left to right. There are spaces in the rubber which i would assume are spaces to allow the rubber to collapse into under stress without tearing. There is a down arrow signalling proper insertion. The bushing is very slightly oblonged with the widest point being the upper and lower part where all the rubber is and the skinnier part being left to right were the spaces in the rubber are. Again this is normal? About a 1/16" difference.
Homemade tool is almost ready. Couldn't find a 1/2 X 8 NF grade 8 bolt at seven eleven so I need to go to the supplier sometime next week to complete my official Brickboard Tab puller per Art again and Erlings page.
--
91 Brick turning 400,000 this month






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New TAB time [200][1991]
posted by  Kenner  on Sat Nov 25 14:05 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.