I installed the pro-start CT3200 from Canadian Tire, made by Autostart in Montreal.

Main 5-pin harness
2 red wires i ran right to the battery. 30A fuses.
yellow wire i tied into acc (1) blue/yellow at the ignition switch
Green wire i tied into acc (2) Blue at the ignition switch
orange wire i tied into heater circuit Yellow at the ignition switch.
Purple wire i tied into starter pink at the igntion switch.

secondary 5-pin harness
Black wire. I grounded at the neg connection in the dash by the heater.
Purple wire. I put a spade connector on and connected to the neg (-) on the Coil
Gray wire. I installed there hood switch and connected it.
Orange wire. I connected to Blue/Red at the brake switch. Make sure it is the switched side of the brake switch and not the live side.
Yellow wire. I tied into white at the light switch. 15A fuse.

3rd 12-pin harness.
Didn't even open the package but I will install auto entry and trunk in the spring, and maybe the panic horn

Phoned there tech service desk twice as i couldn't get the contoller to recognize the transmitter. They were really knowlegeable and cared about me getting this working. Richard told me throw the programming guide that came with the unit out as it was wrong.
Once he taught me the sequencing for programming mode it worked 1st time. No need for tach adjust. It starts perfect.
The also have a good online site that gives you what you need. Only once though.
--
91 Brick turning 400,000 this month