Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

offset 200 1992

posted by  volvo245gti on  Fri Jan 19 17:13 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Sep 13 16:32 CST 2014
[RELATED]

"Your only issue is the offset. At 35mm you only need a 15mm spacer to make up the room."

You can get away with 20mm...See more below...

"More importantly, you will NEED at least a 25mm adapter to hide the lug nut so that it recesses into (or inside of) the spacer. The acorn lug that holds the adapter to you Volvo hib is about 22-24 mm tall. Surely, it cant stick out of the adapter."

It can be done with a 20mm adapter. Use basic 1/2"X20 wheel nuts and there won't be a problem. They can protrude provided the new wheels have hollows between the lug holes on the backside of the hub mating surface. Many wheels do...


”I run adapters and FWD Volvo rims on my car 25mm front/32mm rear so I have some experience in this area.”

I build them…;-)

The only issue I see is as mentioned in my email to you Frank…will the smaller center bore of the wheel allow the end of the front hub through? The rears are fine…

Dale





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Center Bore [200][1992]
posted by  fpeck1948 subscriber  on Thu Jan 18 04:40 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.