Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2014

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Ignition module plug - 87- 240 B230F

posted by  240Kek on  Sat Mar 17 02:30 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue May 8 12:21 CST 2007
[RELATED]

Can the wire plug to the Volvo/Chrysler ignition module be safely disconnected and reconnected without damage to the pins?

The service manual warns that removal of this plug will damage the plug and render it useless. I need to replace some the wires with crumbling insulation.

Should I just cut the wires close to the module and make the mechanical connection there, or can I actually remove the connector and rebuilt it with new wires? I have managed to rebuild/clean/seal from oxydation many connectors, but I'm not familiar with this one. Any guidance as to what to look for would be really helpful.

JimK






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Ignition module plug - 87- 240 B230F
posted by  240Kek  on Sat Mar 17 02:30 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.