Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2001 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

might not be the cap 120-130

posted by  Danny on  Mon Jul 30 07:04 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 6 22:01 CST 2014
[RELATED]

Recently I had a gas smell in the car and after some detective work discovered that the solder joint - filler neck to tank had a crack. Removed tank (and while it was out I cleaned out crud with pea gravel and water) unsoldered, cleaned and retinned mating sufaces and resoldered the filler neck. The most important part of this the fit-up. I placed the tank back in the car and after centering the filler neck in the hole in the body, I tacked it in place, then removed the whole unit and completed the soldering out of the car. This leaking filler neck issue seems to be a common failure and after 40 years and I would do this to any car I got that looks like it might have been bumped in that area. An off center filler neck in the body can indicate the potential for leaking due to failed solder joint.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New What 'm a gonna do about all that junk inside my trunk? [120-130]
posted by  RepairmanJackal subscriber  on Wed Jul 25 14:01 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.