Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2010

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

recprocating saw for exhaust cutting?

posted by  runwld2 on  Sat Feb 23 15:11 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 30 13:11 CST 2014
[RELATED]

Thanks, the recipricating didn't work, as some one mentioned it bounces around and it can't get into the bolts. Used a hand hacksaw. Fortunately the bolts were soft!
A grinder would be better. I should ge more discs for my Dremel.
Well it's almost done. Old one is off. Broke the O2 sensor trying to remove it (any hints on that?).
It looks like the old CAT was on upside down. It had the O2 sensor on the outer lower side, all other Volvos seem to have it on the upper inside. CAT fits better, the heat shield is on top, which makes sense to me.
Just need to get the bolts into the headpipe to CAT flange now.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New recprocating saw for exhaust cutting?
posted by  runwld2 subscriber  on Sat Feb 23 02:46 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.