Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2016 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

I got a big problem............. ! 200

posted by  Paul Driver of Inga on  Tue May 13 16:00 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Mar 25 16:42 CST 2012
[RELATED]

You can chase the threads with a axle grease covered tap made for the job, Take a clean rag and catch shavings or cuttings as you take the tap out and take your time. You do not want to have any junk fall in.

Take a really strong vacuum cleaner and (wait for it), duct tape that sucker to a section of hose that just fits down in the hole. Start with the threads and work your way in. Suck that sucker out like there is no tomorrow.

Apply a liberal coat of nickel coat to the threads and gently run in the new plug.

You should be good to go.

Good Luck and double check that gap before you screw them in all the way.

Regards,

Paul






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New I got a big problem............. ! [200]
posted by  jjnuttall  on Tue May 13 14:59 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.