Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2012

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

No. Me neither!

posted by  Andrew in AL on  Mon Jun 16 08:16 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 06:17 CST 2014
[RELATED]

No. I would not chisel the HB either ...no way!

I just elongated the hole on the tool and it should work now as expected. The hole just needs to be longer like in the IPD version to allow for different makes of HBs. It is not as pretty as I might like now but it will work easier.

This tool was bought for me in exchange for my doing the work. If I had bought it myself and then found the difficulty in using it properly, I think I might be a bit more miffed at the supplier.

Just hope this will help someone else looking to buy the tool.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Followup on counterhold tool for lower pully
posted by  Andrew in AL subscriber  on Mon Jun 16 06:28 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.