Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2003

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

But wouldn't that make it less effective on an OEM HB?

posted by  Andrew in AL on  Mon Jun 16 09:42 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 06:17 CST 2014
[RELATED]

No, Spaz. The elongated hole is vertical when the tool is attached. It just makes allowances if the bolt is up a bit or down a bit, due to mfg. differences in HBs.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Followup on counterhold tool for lower pully
posted by  Andrew in AL subscriber  on Mon Jun 16 06:28 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.