Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

CPS 200 1991

What the $*&#@ do you use to get in there? Long socket?

Having changed several on 89 and 90 cars, I wondered what all the swearing on the board was about - reports some went in from below, etc. Then, last month, I went after the one on the 91, and learned.

In the 91 and up, the AC piping is right where your left elbow needs to be against the firewall to use a box end wrench on that bolt. Laying on the fender helped.

From the top, about 10" of extension, and some wobble makes it possible. Your main objective is to not break the bracket, and secondary, not drop the bolt. A bit of something jammed in the socket helps to put the bolt back in.

Taping the cable sheath won't buy you any time. But taping up that IAC hose should, until you can get to a junkyard or dealer.









91-93 A/C in the way



89-90 clear sailing


--
Art Benstein near Baltimore

Show me a piano falling down a mine shaft, and I'll show you A-flat minor.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1991 240 Rough idle, stalls, no power on acceleration. [200][1991]
posted by  Makoona  on Tue Aug 4 04:55 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.