Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2022 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

ECT sensor - simple installation question. 700

posted by  AMSroadrunner on  Wed Aug 12 15:40 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Aug 25 16:43 CST 2014
[RELATED]

I believe that the new sensor will come with a gasket, a copper one. It should work just fine but a bit of RTV (sold by permatex "Ultra Grey" is the best stuff). There is a drain plug on the on the block near the back. Drain a bit from there and you should be fine.

The only other bit of advice I have is that I had a similar problem. It ended up with a total car rebuild. I also found that it was easier to pull the intake manifold, but if you have small fingers and tons of patience you should be fine.

Andrew






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ECT sensor - simple installation question. [700]
posted by  Forsyth  on Wed Aug 12 08:22 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.