Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2010

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

240 door sagging

posted by  Tarebky on  Sat Mar 20 06:28 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jun 15 10:14 CST 2011
[RELATED]

I also had a sagging door issue on my'82 242 GLT.The drivers door sagged the most but they were both bad.Being employed by a Volvo dealer I didn't think twice as obtaining NOS parts from the factory is a given.When I requested our Parts Dept to place the order I was told they were not available.I then searched the internet to see if pins alone could be sourced but I couldn't find ones specific to the Volvo.Finally I found a pile of Volvo hinges from a independent repair shop and put together the best of the lot and now I have four decent hinge ready to be installed this spring.Anothe alternative is to buy readily available pins and machine the diameter of the sleeves to match.
Good luck,
Tarebky






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 door sagging
posted by  Lord Volvo subscriber  on Fri Mar 19 17:26 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.