Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2001 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Wing vent bottom rivets 120-130

While I was replacing the top 2 rivets, I also replaced one of the bottom rivets that hold the swivel post to the vent window. While the rivet fit fine, It needed to be hammered to bend the inside & outside edges of the rivet so that it didn't try to catch on the aluminum door sil. Just for good measure, I filed down the center of the rivet slightly.

I only used one rivet on the post because rust desolved half of it :) There was no rivet in the remaining hole.

It all works like it should, except the rubber on the bottom could use a little bit of work.

Klaus
--
Praying for Cynthia Amendt, heaven bound






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Removing glass from wing vent [120-130]
posted by  KlausC subscriber  on Fri Mar 26 10:17 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.