Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2005 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Another distributor option 120-130

posted by  planetman on  Wed May 19 15:52 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 09:29 CST 2014
[RELATED]

Hello,

FYI, for the ultimate in adjust-ability, a machine shop 3 doors down from mine makes custom dual point distributors.

They cost $500.00 and use a trick fully adjustable mechanical advance mechanism.

He builds them with needle bearings for the lower end of the shaft and a ball bearing for the upper half, good to 10,000+ RPMs.

For an additional charge, he can make them with an magnetic pickup for use with compatible electronic ignition systems.

Also for an additional charge, a retard option is available in case you have forced induction or nitrous oxide.

--
Eric
Hi Performance Automotive Service (formerly OVO or Old Volvos Only)
Torrance, CA 90502






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Distributer rebuild and Pertronix question [120-130]
posted by  tdskip subscriber  on Sat May 15 03:56 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.