Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Check Engine Light-Coolant Temp Sensor 200 1993

posted by  newmex999 on  Mon Aug 30 13:17 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Aug 21 09:05 CST 2014
[RELATED]

Now that I have completed the replacement of the coolant temp sensor I can explain it so others can benefit.

First of all it is possible to change the sensor without removing the manifold.
Get yourself a deep socket (19mm) and a swivel adapter that goes into the socket along with a 12" extension.

I removed any vacuum hoses that were in the way and was able to loosen the sensor and remove it.

The old sensor had a copper washer on it which I transferred to the new sensor and I also wrapped the new sensor threads with some nylon plumbers tape before installing.

WHen reinstalling I was able to hand tighten as much as possible and then used the 19mm deep socket along with vice clamps which I used to grab the socket from underneath the manifold and really tighten it down

Cleared CEL and all is well.........................
--
1993 240, 1992 240GL, 1985 240DL Wagon, 1983 240DL






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Check Engine Light [200][1993]
posted by  newmex999 subscriber  on Thu Aug 5 01:50 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.