Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2012 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Engine code 2-3-1 on a 240 200 1990

posted by  mshonline on  Sun Oct 24 12:47 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 27 06:54 CST 2010
[RELATED]

From your linked post:
*****
Before you spend any more $$, try starting again with a jumper wire between the LEFT side fuse 4 and 6 contacts. That will run both pumps, while bypassing the 25AMP fuse near the coil and the Fuel relay.

Note that the pumps should as soon as the 4-6 jumper is in place. Let them run for a few seconds to fill the fuel system before you try starting.
*****

is this what I should try? I'm unclear about the sequence. Attach jumper for a few seconds, then do I leave the jumper in place and start? Or do I remove the jumper before starting.

Thanks!
shane






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine code 2-3-1 on a 240 [200][1990]
posted by  mshonline  on Sun Oct 24 01:59 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.