Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Failures on that Chrysler controller are virtually unknown. (NMI) 200 1986

Finding a more up to date ignition system would at least give me one less thing to worry about when they are away from home.

Sounds a little like the pain of a bee sting coming from an engineer.

All the while, because you are an engineer, you know implementing any other solution than the one it came with is inherently less reliable.

But to be helpful, knowing you wrapped the fuel harness up in the steering shaft last week, be aware the ignition harness is attached thereto under the intake manifold, in order to collect TPS information and send out timing for the injectors. Maybe the yank put stress on the V/C's connector? Otherwise, you'd have a hard time convincing me a Megasquirt and spark conversion would seriously be more reliable in a grocery getter than that bulletproof, potted V/C ignition controller. (Aside from its dodgy connector of course)


--
Art Benstein near Baltimore

We could certainly slow the aging process down if it had to work its way through Congress. - Will Rogers






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 86 240 ignition controller [200][1986]
posted by  Big Harry  on Wed Nov 3 10:45 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.