Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2002 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Intermittent No Start -SOLVED - Crank Position Sensor was bad 700 1991

posted by  Strackerjack on  Fri Nov 12 01:53 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 8 19:11 CST 2014
[RELATED]

Thanks to all of the patient, forgiving folks who contributed to the challenge of my PITA intermittent no start problem. (Goatman, Aleekat, lucid, Will740turbo, fixit2002, mmal231294 and everyone else!)

I received the new sensor from FCP Groton. Pulled out the current CPS - outer insulation was pretty thoroughly cracked off but the inner wires looked well insulated - until I got right down to the sensor. Sure enough the inner insulation was degraded just like a pre-88 Volvo wiring harness. The two wires were both exposed and it is amazing the car was actually running at the time.

Since I am too busy to do much service to those who are in need on this board I am gonna make a financial contribution. I am as committed to my old Volvos as I am my body parts... and therefore I will always need this resource.

You guys are great!

Jack






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Intermittent No Start - no it's running - what should I test? [700][1991]
posted by  Strackerjack subscriber  on Sat Nov 6 10:40 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.