Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2017 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Pulled My First Intake Manifold, Misc. Questions 200 1980

posted by  Mandon S. Brontes, esq. on  Mon Apr 18 09:26 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Mar 24 12:16 CST 2012
[RELATED]

I finally got around to pulling my intake manifold so I could install a new set of injector o-rings, gaskets, patch up my wiring harness, and do some much-needed under hood cleaning. So far it's all been pretty straight forward, but messy and time consuming. I'm wondering if there's anything else I should take care of before I sew everything back together? Also, any tips on cleaning dirty valve stems would be greatly appreciated.

Thanks





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Pulled My First Intake Manifold, Misc. Questions [200][1980]
posted by  Mandon S. Brontes, esq.  on Mon Apr 18 09:26 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.