Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2009 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Distributor question 140-160

posted by  Volvo From Heck on  Sat Dec 17 22:43 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 13 20:56 CST 2014
[RELATED]

Joel, I don't think it's a good idea to do without at least the aluminum distributor mount . I don't know offhand which way the cam gear would tend to push the intermediate shaft (with the drive to the oil pump)--probably down towards the pump-----but----the aluminum mount keeps it from going anywhere. If you are concerned about appearance and want to have as clean a look as possible I'll send you an old distributor and mount you can hack apart to your hearts delight. Or just cap off the mount. -- Dave






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Distributor question [140-160]
posted by  Antique Swedish Steel subscriber  on Sat Dec 17 20:58 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.