Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2010 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Quick test for 12V from Ignition switch 700 1990

uid 18083's pic
posted by  lucid on  Fri Oct 12 07:34 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 12:31 CST 2014
[RELATED]

To test for KPII voltage leaving the ignition switch, use a 12V test light at the Starter Service Socket in the pic below. Note that this point is before the Neutral Safety switch, in the circuit to the starter solenoid.

Note that this socket terminal may be a bit corroded due to it's location, so you may not see voltage until terminal has been probed a few times for a good contact.





--
Bruce Young, '93 940-NA (current), 240s (one V8), 140s, 122s, since '63.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Quick Ignition question [700][1990]
posted by  travis873o  on Fri Oct 12 06:38 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.