Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Extra connector on O2 sensor? 200

posted by  someone claiming to be Dexter on  Sat Dec 29 21:06 CST 2012 [RELATED]

I recently purchased a Bosch oxygen sensor ('84 240) that has two connectors. One is a single wire that has a (for lack of better word) male spade type connector that slides into a single wire coming out of the wiring harness and has a rubber boot to cover the point of connection. (The sensor that I pulled from the car had just this kind of connector).

The second connector has two terminals and a clip-on type of connector. Is this the heater? My wiring harness has a connector for this, but right now it is not connected. Should it be?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Extra connector on O2 sensor? [200]
posted by  someone claiming to be Dexter  on Sat Dec 29 21:06 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.