Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

engine 200 1989

posted by  machine man on  Mon Jan 14 19:25 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 15:40 CST 2014
[RELATED]

The connector on the AMM may have a loose or corroded pins inside. You may want to peel the rubber boot back and make sure the pins do not slip upwards when tugged on. Observe the pins after it is connected before putting the rubber boot back in place.

When you cleaned the AMM you may have disturbed them into working again. Without the sensor working the computer may have ran the car in limp mode.

You might want to share more symptoms of how it is running during cold, warming up and after it is up to operating temperature. Are the spark plugs burning clean? How is the mileage is doing?

Phil






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New engine [200][1989]
posted by  triangle  on Mon Jan 14 16:03 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.