Volvo RWD 444-544 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2007 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Fender Repair PV – Stone Guard Mounting Hole Locations 444-544

posted by  jk63pv544 on  Sat Feb 9 17:57 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 1 06:04 CST 2014
[RELATED]

Patching up the driver’s side rear fender on the ‘63 PV. Much metal missing, including a large section that was covered by the Stone Guard.

After replace the missing metal with new sheet metal, I will loose the exact position of the Stone Guard mount holes. I have not ordered the new stone guards yet, so I do not even have them as a reference.

Any recommendations as to how to ensure that I drill the holes in the proper location?

I did a template from the right rear fender holes, but that fender was dented and I had to beet it back out, plus some of the holes have been elongated.

So, what is the best method to ensure that the stone guards will fit properly?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Fender Repair PV – Stone Guard Mounting Hole Locations [444-544]
posted by  jk63pv544  on Sat Feb 9 17:57 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.