Volvo RWD 1800 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2006 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

M41 Overdrive Ball Bearing in Oil Strainer Housing 1800 1965

posted by  dthohler on  Fri Jun 9 18:08 CST 2017
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Sep 19 02:06 CST 2014
[RELATED]

Hello all,

I have a D type OD that I am putting back together.

When I pulled out the oil strainer there was a ball bearing stuck to all the gunk on the bottom. As there is a little hole there, I did not think much of it. But now that I am putting it all back together, it seems that there is nothing that holds the ball in place, as the metal ring and spacers for the strainer do not seem to cover up the hole.

Any ideas? Am I missing a washer to hold it in place?

Please see attached image.

Thanks,
Devin







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New M41 Overdrive Ball Bearing in Oil Strainer Housing [1800][1965]
posted by  dthohler  on Fri Jun 9 18:08 CST 2017 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.