Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2009

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

D-Jet High idle

I have replaced my D-Jet with Megasquirt. So, no cold start valve. I have installed a ball valve on the cold start air intake to raise idle for the A/C and any other time that I need to raise the idle.
My problem is that I can't get the idle low enough. Even with the Idle adjust screw in all the way and the butterfly jammed shut (makes for uneven start ups) The idle is still well above 1000 rpm.
What can be done to reshape the idle adjust jet so it will reduce the air intake?
As a side note, at low throttle settings, under load there is a very annoying and loud whistle which I'm guessing is because of the small throttle opening.

Thanks in advance,
-TR






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New D-Jet High idle
posted by  TR Conn subscriber  on Tue Sep 19 13:06 CST 2017 >
  • New D-Jet High idle
    posted by  Chris Mullet subscriber  on Thu Sep 21 12:36 CST 2017 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.