Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2014 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Hinge hardware 120-130

posted by  Ron Kwas on  Sat Apr 27 08:17 CST 2019
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 04:03 CST 2014
[RELATED]

Forum;

Using the correct bit size (Phillips #3 or 4?) is obviously crucial, but so is pressure into the fastener to prevent camming out with inevitable associated damage (Pozidrive would not to this...unfortunately, they are not...)

...last time I needed to remove a door-hinge, I remember adding a spacer/lever to the other side of door-frame with which to positively press the bit into fastener, and prevent camming out...making this a two man operation...

Can anyone verify is a thread locking compound was applied during installation...if so, heat will defeat this and help.

Cheers






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Hinge hardware [120-130]
posted by  DBS  on Fri Apr 26 05:23 CST 2019 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.