Volvo RWD 1800 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2005 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Engine/Transmission installation 1800

posted by  PBL1 on  Sun Feb 21 07:27 CST 2021
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Thank you Derek for your helpful points. I did spend a lot of time getting the paint perfect as well as the engine bay. I will have a buddy to help and guide as I don't have a remote for the lift. You bring up a great question about the cross member shims which I do recall 10 years ago when I dropped the cross member. Hopefully I did mark them but first I got to find them :) I'll be ready for this installation in a month or so as I first want to install rear end assembly and finish up on the engine rebuild than I'll post some photos. I found last night a short video from the "Mechanic London" episode 31 on YouTube were he does this type of installation, too bad there was not more detail but looks like it went very well for him.

Thanks again,
Peter






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine/Transmission installation [1800]
posted by  PBL1  on Sat Feb 20 16:47 CST 2021 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.