Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2022

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

M46 bearing compatibility?

posted by  mike66 on  Fri May 13 12:51 CST 2022
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Apr 25 15:15 CST 2012
[RELATED]

My P serial# 28 11902611764

My J serial# 27 115938 010309

SIDE NOTE: While taking my J type apart I see what went wrong inside of it. I guess that when I was removing and installing driveshaft flange from the 740 (with the bell housing removed) Somehow I separated the input shaft from the output shaft, hence why my bearing was sticking out too far to install the bellhousing. Before I knew this I tried to move the shift lever and something popped inside. one of the locating keys had fallen out and I found a snap spring that is about 3/4 of a circle with hooked ends. It is bent and I have no clue where it went. Thinking I can just take it apart and reassemble it. But I also noticed that there is a gear on my layshaft that has 2 big chips missing. Gear clash I guess. I'm starting to think I need to to just find a good used transmission.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New M46 bearing compatibility?
posted by  mike66  on Wed May 11 14:30 CST 2022 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.