Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2003 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: engine swap 140-160 69-72

posted by  someone claiming to be Bill Whitehurst on  Wed Nov 29 14:31 CST 2000 [RELATED]

Pretty simple swap. You might have the B 20E which is 10.5:1 compression and will run REAL strong! If it is be very sure it gets GOOD gas.

More likely you have the low compression B20F which is still OK. It has bigger intake valves than your old B20B and a little more lift on the cam (but with the same duration).The Strombergs will get you goin' and if they are in good shape they'll be fine for some time. However the fuel injection is better all around and not too hard to swap in IF it is still intact and working.

Oh and the top starter bolt goes in from the front with the nut on the backside. You can remove the distributor for clearance by taking out the two 1/4 inch cap screws that hold the aluminum flange to the block.

Congrats on getting a neat car for cheap!





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New engine swap [140-160][69-72]
posted by  someone claiming to be Beck  on Mon Nov 27 14:51 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.