Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: aligning flexiplate for angular motion sensor 200 88

posted by  someone claiming to be Winston on  Fri Apr 27 08:49 CST 2001 [RELATED]

Mike, Turn the crankshaft so that #1cylinder is at TDC 2, position drive plate on the crankshaft so that pin (A) is approximately 15degree from the horizontal position and pointing away from the starter motor mounting. Note that there are two pins (A) & (B) Good luck.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New aligning flexiplate for angular motion sensor [200][88]
posted by  someone claiming to be mike  on Fri Apr 27 06:10 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.