Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2002 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

My ignition lock cylinder has split...what shall I do? 140-160 1972

posted by  walrus3 on  Sun Jan 20 10:08 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Dec 2 14:20 CST 2013
[RELATED]

You don't have to drill out the bolts.
You can slot them with abrasive cutoff disks in your Dremel Moto-Tool
or equivalent and then remove them with a screwdriver.

I have a much better lock for mine but have not installed it yet.
What I did was to take all the tumblers out of my old lock cylinder
and put it back together. It works fine. Not only that but it doesn't
matter which key you use......
--
George Downs Bartlesville, Oklahoma






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New My ignition lock cylinder has split...what shall I do? [140-160][1972]
posted by  Anthony H.  on Sat Jan 19 21:14 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.