Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Intake torque??? 200 1983

posted by  Clalian on  Sat Feb 16 01:15 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Bruce S.:
Here's what I found in my "Haynes" manual. The intake manifold should go with 16 ft-lbs of torque. Here's the text:

"15. Install the intake manifold with a new gasket and tighten the bolts finger-tight. Starting at the center and working out in both directions tigthen the bolts in a criss-cross pattern until the torque listed in this Chapter's Specifications is reached."

Hope this helps!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Intake torque??? [200][1983]
posted by  Bruce S. subscriber  on Fri Feb 15 13:57 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.