Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

yes and no. 700

posted by  someone claiming to be JohnB on  Sat Aug 10 01:07 CST 2002 [RELATED]

Chances are the parts guy is giving you the wrong bearing/seal. I would think they're different from the integrated hub and the big brake separate hub/rotor conversion.

On the good news side, evidently your car got the separate hub/rotor conversion installed after 87 when they were developed to cure brake wear problems with the inadequate integrated hub/rotor front brake.

Look in the FAQ and see if those separate hub/rotor brake assemblies use a sealed/pressed bearing (my 90 740T apparently does, but it's girling vice the bendix if abs you may have) If the parts guy lists separate bearings/seals for the two different hubs, I'd probably try and replace them.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Wheel bearings easy to do on 85 744T? [700]
posted by  slicker  on Fri Aug 9 15:00 CST 2002 >
  • New yes and no. [700]
    posted by  someone claiming to be JohnB  on Sat Aug 10 01:07 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.