Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2008

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

1 or 2 pieces?

I dunno...I've seen 2 totally different gasket sets for the b230 engine. My parts guy insisted that I needed the 2 piece set, because the 2 piece set comes with a little half-moon rubber plug in it, and he said i needed it, so I had to bring him out to my car and show him that I needed a one-piece gasket, since mine didn't have that little half-moon thing. I've had 3 cars with the b230 engine, and none of them has needed that plug, but I have seen references to it in (I think) the haynes manual. You might want to check it out before you buy one. Also, you might want to try ordering from fcp groton, or at least checking out their website- they have pictures to go with most of their items. That way, you can be sure you're ordering the right one.
Color, though, won't matter. You should probably get some rtv and dab a bit into the corners around the cam shaft, at the bottom of the little humps. The gaskets don't tend to seal very well around there without it. Have fun!
--
1985 245 205k and counting. Charter member of the Martha Stewart Racing Team- "It's a good thing"






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New correct valve cover gasket for B230F?
posted by  Swen  on Sun Sep 29 14:07 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.