Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2003 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Ignition Modification for 122. 120-130 1967

posted by  walrus3 on  Fri Nov 15 06:49 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Dec 2 14:20 CST 2013
[RELATED]

Gotta remember that the switch is 35 years old!

There are a number of aftermarket ignition switches that you can install
in a 122. The hardest part is getting through the armored cable without
damaging the wires too much. I've yet to see a 122 with a bad coil, so
I would recommend that you do this. I think a partial replacement of the
switch is not a good idea because you are not sure exactly which circuit is
bad. The aftermarket switch I am using came from Stephane Lapointe in
Quebec. I believe it cost about $10.
--
George Downs, The "original" Walrus3, Bartlesville, Oklahoma






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Ignition Modification for 122. [120-130][1967]
posted by  c. a. subscriber  on Fri Nov 15 05:42 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.