Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2019

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

air control motor

posted by  runwld2 on  Mon Nov 25 14:53 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 30 13:11 CST 2014
[RELATED]

If this a CIS system motor (pre LH), then if you are using a DC meter you may not see anything as the signal is AC.
The center terminal is ground and the other two are out of phase square waves.
Check with a good AC meter or an oscilloscope.
If truly no signal then either the controller box (located next to Lambda controller at right kick panel) is bad or wiring from coil to box is open.
I have fixed the boxes. It requires replaceing blown transistors.
Or go to junkyard.
If interestd in box repair, email me.....
--
744-16v,745-16v,242Turbo.245DLT






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New air control motor
posted by  mudduck  on Mon Nov 18 14:14 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.